7 Steps to Pleasant Coolness: How to Install the Air Conditioner Properly

7 Steps to Pleasant Coolness: How to Install the Air Conditioner Properly

If you install the air conditioner yourself, you need to approach the case with increased responsibility. And if the device is regulated by a service, you must monitor their actions.

Summer is ahead, which means many people will install air conditioners in their apartments. Some people turn to professional contractors such as the HVAC Kenosha for this, others look for services through the shop where the equipment was purchased, while others try to do it themselves. However, no one is immune to mistakes. The following is a sequence of steps when installing the AC, as well as very common errors.

The first step – When installing an air conditioner is to choose the place where it will actually be installed. Experts argue that the coolest air will be at a distance of about two to three meters from the air conditioner. And this means that the service installer or apartment owner must choose a place such that there are no couches, beds, or couches in the AC area.

It is very important to remember that the air conditioner must be placed in a place that is removed from all the heating furnishings in the house. Sometimes the conditioner is installed in the kitchen. In this case, the device must be away from the electric or gas stove.

The second step – Choose the type of air conditioner that will stand in the apartment or at home. Now usually installed split systems, which consist of external and internal units – that is, of the condenser and evaporator. They are quite simple to operate because they are connected by tubes, where all the wires are needed for operation and freon cooling.

No permission is required for this. Except for homes in historic buildings, when air conditioners can interfere with the appearance of the facade.

The third step – Install a separate power cord before installing the AC. This is done directly from the shield and is needed so as not to knock out the plug and there is no shortage due to excessive load on this or that wire. Also, prepare a hole for the freon tube.

The fourth step – The installation of a condenser. Before working, you must choose a reliable bracket that will withstand the AC load. Important point (-) must be affixed directly to the wall of the house, and not to the skin. If the air conditioner is regulated by service, the owner must follow this moment.

The fifth step – Always need to extend the drainage tube. Such an operation will cause the liquid to drip along the wall along the line where there is no window gap. But if the drainage tube is not extended, water will flow directly into the window.

The sixth step – Place the indoor unit correctly. Some “craftsmen” place them in inconspicuous places, for example, under cupboards. But this interferes with the device’s normal operation and can cause a fire.

The seventh step – Connecting external and internal blocks. There is one important thing here – make sure that both units are installed correctly. If the apartment or service owner does not do this, the condensate will start to pile up, which will cause damage to the device.

The principle of installing an air conditioner is very simple, but the details are important, therefore, if you install the air conditioner yourself, you must approach this problem with increased responsibility. And if the device is regulated by a service, you must closely monitor their actions, so you don’t have to pay to repair the air conditioner.

https://goo.gl/maps/w5Yy57Tvm6x